GE GSS1800H Series, Руководство по установке, Страница: 7 / 16

7
Figure 7
Entry Must be
Above Trap
Sink at Left
Sink at Right
“Y” Branch
Tailpiece
2” Drain Hose Hole
Connecting to a Sink Drain
Figure 8
Drain Air Gap
Sink at Right
Remove
Knockout
Plug in
Disposer
2” Drain Hose Hole
Alternate
Drain Through
Floor into
Separate Trap
• If you connect to a sink drain, using the “Y” Branch Tailpiece and Connector Kit, available at plumbing and
hardware stores, will make this connection easier. The kit includes all of the necessary fittings and
complete installation instructions.
• If you connect to a disposer, use the larger end of the corrugated hose which has been designed to fit the
disposer without any special connectors (
see inset of Figure 7).
NOTE: Be sure to remove the knockout plug from inside the disposer inlet fitting before attaching the
drain hose.
If the drain hose is to be routed through the floor to a separate trap, the trap must be vented to prevent
siphoning. To provide proper venting, install the Air Gap Kit, available at plumbing and hardware stores, into
the countertop. Route the drain hose up to the inlet side of the air gap. Continue drain line from outlet side of air
gap down through floor to separate trap (
see Figure 8).
Do not cut the corrugated drain hose. Excess corrugated hose should be placed flat on the floor in the
dishwasher cabinet.
Make sure the hose does not come into contact with any sharp edges.
Connecting to a Disposer
Sink at Left
Cut for
5
/
8
” connection.
Drain
Motor
End
Cut for 3/4” connection.
Larger end
of hose
fits disposer
inlet fitting.
Drain Hose