How to disconnect the Unicouple from faucet adapter
1. Turn off the hot water.
3. Release Unicouple from faucet by depressing
2. Release the water pressure by depressing
the collar at the top of the Unicouple connector.
the pressure release button. This relieves
water pressure and protects you, and the
room, from severe splashing.
How to disconnect your dishwasher
1. Remove the power cord plug from the wall
NOTE: When motor stops at the end of the
receptacle.
final rinse, the Unicouple can be disconnected
2. Disconnect Unicouple from faucet adapter.
and returned to storage.
How to drain excess water from Unicouple hoses
If the sink is 34” or higher from the floor,
the excess water in Unicouple hoses cannot be
drained directly into the sink. It will be necessary to
drain excess water from hoses into a bowl or suitable
container that is
outside and lower than the sink.
HOW TO CONNECT
Caution, for personal safety:
DO NOT USE AN EXTENSION CORD OR
AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD.
Dishwasher must be electrically grounded in accordance with local codes and ordinances, or in the
absence of local codes, in accordance with the NATIONAL ELECTRICAL CODE,
NO. 7&1987.
Electrical requirements
●
This appliance must be
supplied with
60 Hz,
and connected to an individual,
properly grounded branch circuit,
protected by a 15 or 20 amp circuit
breaker or
fuse.
●
If the electric supply
o
provided does not meet the above
INSURE PROPER
specifications, it is recommended
GROUND EXISTS
that
a licensed electrician install
BEFORE USE
an approved outlet.
●
Your dishwasher circuit
should not be used for any
other appliance while the
dishwasher is in operation as
the dishwasher requires the full
capacity of the circuit.
●
If the wall receptacle you
plug the dishwasher’s power
cord into is controlled by a
switch, turn on the switch.
5
