SPECIAL INSTALLATION REQUIREMENTS
Listed by
Underwriters
Laboratories
Specification Revised 2/16
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
GFWN1100H
GE Appliances Energy Star
®
3.6 DOE IEC Cu. Ft. Capacity
Frontload Washer With Stainless Steel Basket
STACKED INSTALLATION:
- Brackets for stacking dryer over washer are not included with the washer.
Order part no. GEFLSTACK or part no. WE25X10018.
ALCOVE OR CLOSET INSTALLATION:
- If your dryer is approved for installation in an alcove or closet, it will be
stated on a label on the dryer back.
-The dryer MUST be exhausted to the outside.
-Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 0" either side, 3" front and rear
-Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
- Closet doors must be louvered or otherwise ventilated and must contain a
minimum of 60 sq. in. of open area equally distributed. If this closet
contains both a washer and a dryer, doors must contain a minimum of 120
sq. in. of open area equally distributed.
-No other fuel-burning appliance shall be installed in the same closet with
a gas dryer.
BATHROOM OR BEDROOM INSTALLATION:
-The dryer MUST be exhausted to the outdoors.
-The installation must conform with the local codes, or in the absence
of local codes, with the National Electric Code and National Fuel Gas Code,
ANSI Z223.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INSTALLATIONS:
-Minimum clearances to combustible surfaces 0" both sides, 3" rear.
FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.
STACKED DIMENSIONS
(IN INCHES)
27"
13"
28-3/4"
PEDESTAL DIMENSIONS
(IN INCHES)
SBSD137HWW - WHITE
This optional 13" pedestal
raises the door opening and
height of the washer or dryer.
Feet on 13" pedestal allow it to
adjust to 13-3/8" height.
79-5/8"
Above illustrations intended for dimensional reference only.
Refer to photography for actual product appearance.