5
Installation Instructions
PREPARE HOT WATER LINE
•The line may enter from Either side, rear or floor within the
shaded area shown in Figure F.
•The line may pass through the same hole as the
electrical cable and Drain hose. Or, Cut an additional
1-1/2” dia. hole to accommodate the water line.
If power cord with plug is used, water line Must not pass
through power cord hole.
Water Line Connection
•Turn off the water supply.
Install a hand shut-off valve in an accessible location, such
as under the sink. (Optional, but strongly recommended
and may be required by local codes.)
•Water connection is on the left side of the dishwasher.
Install the hot water inlet line, using no less than 3/8” O.D.
copper tubing. Route the line as shown in Figure F and
extend forward at least 18”from rear wall.
•Adjust water heater for 120 F to 150 F temperature.
•Flush water line to clean out debris.
•The hot water supply line pressure must be 20-120PSI.
Figure 6
Cabinet Face
Shut-off
Valve
3" From Floor
18" From Wall
4"
From
Cabinet
1-1/2" Dia.
Hole
Hot
CAUTION:
Opening the door will cause the
dishwasher to tip forward.
Do not
open the door until you are ready
to install the dishwasher
. If it is
necessary to open the door, hold the
top of the dishwasher securely with
one hand and hold the door with the
other hand.
PRECAUCIÓN:
Abrir la puerta hará que el lavaplatos se incline hacia
adelante. No abra la puerta hasta que esté listo para
instalar el lavaplatos. Si es necesario abrir la puerta,
sostenga la parte superior del lavaplatos firmemente con
una mano y sujete la puerta con la otra.
BEFORE YOU BEGIN
Locate and set aside the package containing
2 phillips head counter top mounting screws
and 2 additional toekickscrews (located in the
literature).
STOP
STEP 1 – CHECK DOOR BALANCE
To check the door balance,hold the top of the diswasher
firmly.
• Open the door slowly, if the door drops when released,
increase spring tension. If the door closes when released,
decrease tension.
• Pull the spring adjustment pin out of the holes,insert
in the next highest or lowest hole and test again.
• Adjust both door springs to the same tension.
• Continue moving the spring pin until door is balance.
Figure G
Increase
Decrease
Figure 7
