Installation Instructions
8
$'',1*(/%2:)25(;+$867
THROUGH BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect
it to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 7.
$'',1*&29(53/$7(725($52)
CABINET
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate (Kit
WE1M454) available from your local service provider. Place
GU\HULQ¿QDOORFDWLRQ
:$51,1*
1(9(5/($9(7+(
%$&.23(1,1*:,7+2877+(3/$7(
PL ATE
(KIT WE1M454)
CAUTION:
Int
e
rnal duct joints must b
e
s
e
cur
e
d with tap
e
,
oth
e
rwis
e
th
e
y may s
e
parat
e
and caus
e
a
saf
e
ty hazard.
CHANGING DIRECTION OF DOOR OPENING
1.
2SHQWKHGRRUDQGUHPRYHWKH¿OOHUSOXJVRSSRVLWHWKH
hinges. With the door completely open, remove the
bottom screws from each hinge on the dryer face. Insert
these screws about half way into the
TOP
holes, for each
KLQJHRQWKHRSSRVLWHVLGHZKHUH\RXUHPRYHGWKH¿OOHU
SOXJV$SSO\¿UPSUHVVXUHWRJHWWKHVFUHZVVWDUWHG
2. Loosen the top screws from each hinge on the dryer
face half way. With one hand holding the top of the door
and the other hand holding the bottom, remove the
door from the dryer by lifting it
UP
and
OFF
.
3. Remove the blind plate from
the hinge side of the dryer
by removing its two screws.
Remove the strike plate
from the opposite side of the
dryer by removing its two
screws. Reinstall the plates,
on the opposite sides, using
two screws in each plate.
4. Rotate the door 180º. Insert the door on the opposite
side of the opening by moving the door
ON
and
DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step 1.
5. Remove the remaining screws from the side of the
opening from which the door was removed. With these
screws secure each hinge at the bottom. Tighten the
two top screws on each hinge. Reinsert the plastic plugs
on the side from which the door was removed.
LOOSEN EACH TOP HINGE
SCREW HALF WAY AND LIFT
THE DOOR UP AND OFF
14
ROTATE DOOR 180º AND HANG
IT ON TOP HINGE SCREWS
INSTALL AND TIGHTEN BOTTOM
SCREWS AND TIGHTEN TOP
SCREWS
INSERT PLUGS
INTO HOLES ON
OPPOSITE SIDE
FRONT PANEL
SWITCH
STRIKE
PLATE
BLIND
PLATE
REMOVE
BOTTOM
SCREW FROM EACH HINGE
AND INSTALL HALF WAY INTO EACH
TOP
OF
OPPOSITE HINGE HOLES
REMOVE 4 PLUGS AND KEEP
FOR INSERTION INTO
THE OPPOSITE SIDE
