49-60765
2
REMOVE THE REFRIGERATOR DOORS
A.
Starting with the left-hand side, open the
refrigerator door enough to allow easy access
to the bottom hinge cover.
B.
8VLQJD´QXWGULYHUUHPRYHWKHVFUHZ
from the bottom hinge cover, and then pull off
the cover.
C.
'LVFRQQHFWWKHZLULQJKDUQHVVHVE\SUHVVLQJ
the release catch on the wire harness
connector and pulling the ends apart.
NOTE:
There are 3 wire harness connections
behind the left-hand, bottom hinge cover,
and 1 wire harness connection behind the
right-hand, bottom hinge cover.
D.
8VLQJD´QXWGULYHUUHPRYHWKHJURXQG
screw. Separate the two ground wires so
that the ground wire coming from the door
can later be easily pulled through the bottom
hinge pin.
E.
Gently grasp the section of the water line that
is coming from the door. Press down on the
collar of the 90° elbow connector to release
the water line, and then gently pull the water
line from the elbow connector.
IMPORTANT:
7KHZDWHUOLQH0867EH
disconnected from the door end of the
connection to allow the water line to pass
through the bottom hinge pin.
F.
Close the refrigerator door, so that the door
gasket will help hold the door in place while
you are removing the center hinge pin.
G.
,QVHUWWKHWLSRIDIODWEODGHVFUHZGULYHU
between the hinge clip tab and the center
hinge. Pry the hinge clip away from the hinge
to disengage the clip from the hinge pin, and
then remove the clip with your fingers and set
it aside.
H.
Open the refrigerator door so that it is at a
90° angle to the cabinet.
I.
Lift up to remove the hinge pin and inner cam.
The inner cam will stay with the hinge pin.
NOTE:
The outer adjustable cam will be
resting freely on the center hinge. Remove
WKHFDPDQGNHHSLWLQDVDIHSODFH,WZLOOEH
needed to reinstall the center hinge.
Installation Instructions
INSTALLING THE REFRIGERATOR (Continued)
Bottom Hinge
Cover
Wire
Harness(es)
90° Elbow (water
line connection)
Ground Wire
(from door)
Ground Wire
(from cabinet)
Green
Ground
Screw
Collar
Clip Tab
,QQHU&DP
Outer
Adjustable
Cam
Hinge Pin
INST
ALLA
TION INSTRUCTIONS
