
Installation Instructions
11
• Align the toekick with the bottom edge and make
sure it is against the floor.
• Insert and tighten the two toekick attachment
screws. The toekick should stay in contact with the
floor.
TIP:
Make sure toekick is against floor to minimize
noise.
FigureBB
STEP 19 LITERATURE
• Be sure to leave complete literature package and
installation instructions with the consumer.
STEP 18 REPLACE TOEKICK
• Place toekick against the legs of the dishwasher.
STEP 17
DISHWASHER WET TEST
¨
Turn on power supply (or plug power cord into
outlet, if equipped).
¨
Latch door.
¨
Push “Normal Wash” button.
¨
Push start/reset pad once.
¨
Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to be
sure that water and power is turned on.
¨
Check for leaks under the dishwasher. If leak is
found, turn power supply off, then tighten connec-
tions. Restore power after leak is corrected.
¨
Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the dish-
washer if necessary. See Step 12.
¨
The dishwasher will drain about 5 minutes after the
first fill. Check drain lines. If leaks are found, turn
power off, correct as necessary. See Step 14.
¨
Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 14.
¨
Let dishwasher run through another fill and drain
cycle. Check again for leaks and correct as required.
¨
At the end of the second drain, push the start/reset
pad once. Wait for dishwasher to pump out and
then unlatch the door.
Attachment Screws
T
oekick