GE Druck DPI 832, Руководство пользователя, Страница: 13 / 131

6
- [EN] English
K393 Issue 3
Operation
This section gives examples of how to connect and use the
instrument. Before you start:
• Read and understand the “Safety” section.
• Do not use a damaged instrument.
Operation - Electrical connections
To prevent instrument errors, make sure that the electrical
connections (A1-item [10] and/or A2) are correct.
Operation - Communications port connections
Use the communications port (A1 - item [9]) to attach an
IDOS Universal Measurement Module (UMM).
When you attach the cable from a UMM (Figure 6/7), the
instrument automatically changes the menus to give you
all the applicable options (Table 2/3).
Operation - Measure mV or Volts
To measure mV or Volts:
1. Connect the instrument (Figure 1) and, if necessary,
adjust the Set Up (Table 1).
2. Select the Volts input task from Select Task (Table 2/3)
and select the necessary range ( mV or Volts ).
3. If necessary, adjust the Settings (Table 4).
Figure 1: Example configuration - To measure mV
or Volts
Operation - Change the output values
When the output operation is set up (Table 5), use one of
these procedures to change the output values:
Table 7: Procedures to change the output
Example procedure (“Nudge” output):
Settings
Volts
mV
Volts
0 ... ±120mV
0 ... ±30V
Output Procedure
Select Edit ( ■ ■ ) and/or use the ▲ ▼ buttons.
See the example below.
,
Select Start/Stop ( ■ ■ ) or use the ▲ ▼ buttons
to make the step changes manually.
Select
Start/Stop (
■ ■
).
Display:
mA output
1 Edit 2 3 Edit 4
■ ■ ■ ■ ▲
▼
+01.000
Sk1 = Edit
Sk2 = Settings
Display:
mA output
5 6
▲
▼
2.000
▲
▼
3.000
Increment = 1.000
(Table 5)