GE Druck DPI 800, Руководство пользователя

Страница: 10 / 15

8
- [EN] English
K335 Issue 3
Operation - mA measurements
DPI 802/802P only. To measure a current:
1. Connect the instrument (Figure 7) and, if necessary,
adjust the Set Up (Table 1).
2. Select the applicable mA task from Select Task
(Table 2/3) and, if necessary, adjust the Settings
(Table 4).
Figure 7: Example configuration - mA measurement
Operation - UPM Pressure measurements
Read all the instructions supplied with the UPM and then
use the specified procedures to connect it (Figure 8).
Figure 8: Example configuration - Pressure measurement
with a UPM
When the connections are complete, make the necessary
IDOS selections (Table 2/3). Then use the same procedures
as specified for the P1/P2 connections.
If you re-attach a UPM, the instrument uses the same
measurement units that you used before. The instrument
keeps a record for the last 10 modules.
Operation - Error indications
If the display shows <<<< or >>>> :
• Make sure that the range is correct.
• Make sure that all the related equipment and
connections are serviceable.
Settings Settings
a) with external loop
power
b) with internal loop
power
Maximum: 30V
Settings
a) Pressure b) Leak test
Start Settings