[EN] English - K0454 Issue 1
Installation
7
5
Installation
Before you start:
•
Read and understand the “Safety” section.
•
Do not use damaged equipment.
Note:
Use only original parts supplied by the manufacturer.
5.1 AMC battery
See figure A3 (front cover).
5.2 Indicator
assembly
Optional item (
MC 620
/
PM 620
)
. See figure B2 (front cover).
5.3 Electrical
connections
See figure C1 to C5, and D1 (front cover).
5.4 External pressure
connections
See figure B1/E1 (front cover). Use an applicable method to
seal the external pressure connections, and then tighten to the
applicable torque. Maximum torque:
1/8 NPT: 35 Nm (26 lbf.ft)
G1/8: 25 Nm (18.4 lbf.ft)
A3
Step
Procedure
1.
When the power is off, loosen the five screws (a) and remove
the cover (b).
If necessary, turn the instrument over and let the discharged
battery drop into your hand.
2.
Install the new battery correctly until it is flat in the
compartment.
3.
Re-attach the cover.
B2
Step
Procedure
1.
Align the two slots (a) on the calibrator with the two posts (b) on
the module carrier.
2.
When the posts are fully engaged in the slots, tighten the two
screws until they are hand tight.
3.
Attach one or two PM 620 modules with the correct range and
type.
4.
Tighten each one until it is hand tight only.
