GE Druck ADTS 542F, Инструкция по безопасности и установке

Страница: 5 / 260

Power Supply
© 2014 General Electric Company – All rights reserved. ADTS Safety and Installation Guide-English | 5
1.4 Power Supply
1.5 Power Supply Connection
Do not apply electrical power outside the values stated.
Make sure that the power supply is off before connecting the power cable.
The ADTS must be connected to the correct electrical power supply as stated, adjacent to the
power connector.
1.6 Fuses
The two High Breaking Capacity fuses (8) (see Figure 3.1), located in the holders and mounted
on the front panel, protect the unit. The fuses are connected in the live and neutral supply
circuit and are rated at: T5AH 250V.
1.7 Replacing a Fuse
1. Disconnect the electrical power supply.
2. Unscrew the fuse holder cap from the front panel and remove the fuse.
3. Fit a new fuse of the correct size and rating into the fuse holder cap.
4. Secure the fuse holder cap in the front panel.
Single phase
110/230 Vac, 50/60Hz
115 Vac, 400Hz
200 VA Max - ADTS542F/ADTS552F
300 VA Max - ADTS553F/ADTS554F
RISK OF ELECTRIC SHOCK
There is a risk of electric shock/
electrocution if there is not a protective earth in place. The ADTS must, at
all times, be connected to the supply protective earth/ground.
The power supply cable and connector must be correctly rated for the
power supply. Only use power cables supplied by GE specifically for the
ADTS.
European Color US Color Function
Brown Black Live
Blue White Neutral
Green/Yellow Green Protective Earth (Ground)