GE DDE6608L, Инструкция по эксплуатации и уходу, Страница: 11 / 16

PROBLEM
KNITS
PERMANENT PRESS
AND “NO-IRON”
ITEMS
POSSIBLE CAUSE AND REMEDY
●
shrinkage
can occur in fabrics that have been improperly stretched
and elongated by the manufacturer. When this occurs, garment maybe pressed back into
shape after each wash and dry cycle.
●
Progressive or delayed shrinkage
is caused when starch or sizing (in some fabrics) is
gradually removed by laundering. Maybe noticed in older garments that have been
many times without previous shrinkage. Treat as for Relaxation Shrinkage above.
●
Shrinkage caused by overheating
occurs in certain knit fabrics that have been
shaped. When washing, drying or ironing temperatures exceed the temperatures used to
shape set, shrinkage may occur. This cannot be corrected, but it can be prevented by
washing in cold or warm water.
●
Leaving clothes in dryer tumbling stops. Remove clothes promptly and hang
them immediately.
●
Too many items in dryer. Dry only one washer load at a time. Do not combine loads.
●
Too few items in dryer. If drying one article, add two or more similar articles, even
if dry, to insure proper tumbling.
●
Improper loads. Avoid laundering heavy Permanent Press items, such as work clothes,
with lighter Permanent Press items, such as shirts or blouses. Do not wash or dry
Permanent Press with regular laundry.
●
Too many clothes in washer. Items must have room to move freely. Permanent Press
loads should always be smaller than regular loads.. more than medium loads.
●
Use of incorrect wash and dry cycles. Use Permanent Press Wash Cycle which provides
a cool-down rinse to minimize
●
Incorrect water level, Use large water level for medium load; medium level or half full
for small load.
●
water with
plenty of detergent.