Installation Instructions
REVERSING THE DOOR (cont.)
14
6
With the cover caps and door handle in place, mount
the inner door back into the outer door with the
screws removed in step 4. Make sure you mount the
hinges on the side opposite the handle.
7
Mount the assembled door on the 2 upper left side
hinge screws installed in step 2. Move the hinge
screws loosened in step 3 into the lower left side
screw holes and firmly tighten all 4 screws.
8
Install the 4 plastic caps removed in step 1 into the 4
right side front panel holes.
NOTE:
To return the door to the original setup, follow
these instructions, swapping “left” and “right”.
When you finish
Plug the dryer back into
its electrical outlet.
5
Remove and swap the 2 cover caps and door handle
from the outer door:
A.
Squeeze the tabs on the inside of the door handle
clips. Push clips through the outer door.
B.
Squeeze the tabs on the inside of the cover caps.
Push caps through the outer door.
C.
Push the door handle clips into the openings on the
opposite side of the outer door making sure you
flip the handle so it curves to the inside.
D.
Push the cover caps into the openings on the outer
door where the handle was removed.
Door handle
Door handle clip
Cover cap
Inside of door
Door
Hang door and
tighten screws
Edge
screws
Door
hinge
screws
Inside screws
Inside screws
Handle
Door handle
Door
handle
clip
Inside of door
Cover caps
