3. Install sash-stopping speed clips on top and
bottom inside edge of window frame (Fig. 5).
4. Cut plastic foam seal (without adhesive back)
to proper length and stuff it between the inside
window sash and the outside window (Fig. 5).
5. Place top retainer on top edge of filler panel
(Fig. 4), then place bottom edge of filler panel into
groove of bottom retainer (mounted on unit). Filler
panel may be trimmed with knife or scissors to fit
window height.
6. Slide right-hand slider upward, making sure
filler panel aligns in slider (Fig. 5).
7. With slider up against top retainer, drill 1/8”
hole through window frame in alignment with
existing hole in slider. Install self-threading screw
in hole (Fig. 5).
8. Repeat steps 6 and 7 for left-hand slider (Fig. 5).
9. Check all seals and plug all air leaks around unit
with suitable weather-proof sealing compound.
Left-hand slider
Self-threading screw
Typical horizontal sliding window unit shown
mounted in
on
assembly,
10
