GE ASD06*, Руководство пользователя и инструкции по установке

Страница: 4 / 40

4
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
■
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
■
The remote control signal has a range of
up to 21 feet.
■
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
■
Make sure batteries are fresh and installed
correctly—see the
Care and Cleaning
section.
About the controls on the air conditioner—models with touch pads.
Features and appearance will vary.
Air Conditioner Controls
On/Off
Turns air conditioner on and off.
Display
Displays the set temperature or time
remaining on timer.
Mode
Use to set the air conditioner to
Cool
or
Fan
mode.
Increase
▲
/Decrease
▼
Pads
Use to set temperature when in
Cool
mode.
Fan
Use to set the fan speed at Low, Med or High .
Circulaire
(on some models)
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn On
until the desired air direction is obtained,
then turn it
Off
.
Energy Saver–
Controls the fan.
On— The fan and compressor cycle on and
off. This results in wider variations of room
temperature and humidity. Normally used
when the room is unoccupied.
Note: The fan
will continue to run for a short time after the
compressor cycles off.
Off—
The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at
Off
in order to use
the fan settings (on the mode control).
Timer
On—
When the air conditioner is off, it can be
set to automatically turn on in 1 to 24 hours
at its previous setting. Each touch will set the
time in hours.
Off—
When the air conditioner is on, it can
be set to automatically turn off in 1 to 24
hours. Each touch will set the time in hours.
To cancel the timer, press the
Timer
pad
until the display time disappears.
Sleep
(on some models)
Press to set the air conditioner to run for
8 hours before it automatically shuts off.
One hour after the sleep timer is set, the set
temperature will automatically increase 2°F.
To cancel the sleep mode, press the Sleep pad
a second time.
Note: The sleep timer will be cancelled if the
Timer, Energy Saver or Mode pad is pressed.
Remote Control Signal Receiver
Remote Control
ENERGY
SAVER On
TIMER On
Remote Control
COOL On FAN On
SLEEP On