GE AMH06, Инструкция по использованию, уходу и установке

Страница: 9 / 16

9
WINDOW INSTALLATION
7. INSTALL THE WINDOW LOCKING
BRACKET.
8. INSTALL THE AIR CONDITIONER IN
THE CASE.
•
Slide the air conditioner into the case. Do not
push on the controls or the finned coils. Make
sure the air conditioner is firmly seated toward
the rear of the case.
10. CHECK FOR AIR LEAKS AND
REPLACE THE FRONT GRILLE.
•
Seal small openings around the case with the
sealer provided.
•
Replace the front grille and the air filter.
See the Care and Cleaning section.
6. INSTALL THE FOAM TOP WINDOW
GASKET.
5. INSTALL THE CASE IN THE WINDOW.
•
Install the case into the opening and center on the
line marked. Lower the window behind the top
mounting rail. The case should be installed level or
with a slight tilt toward the outside.
Cut the
sealing ribbon
to the window
width and
stick adhesive
side to the
bottom of the
lower window
sash.
Measure and mark
the centerline.
Extend the left
and right
window filler
panels to the
vertical window
sashes.
Use 4
type A
screws.
Reinstall the
locking brackets
and screws
removed earlier.
Use 2 type A
screws.
Secure
the top
mounting
rail with 2
type C
screws.
Cut the foam top
window gasket to
the window width.
Stuff the foam between the glass and the window to
prevent air and insects from getting into the room.
Window locking
bracket - Use a
type A screw.
9. RECONNECT THE GROUND WIRE.
IMPORTANT!
•
Reconnect the ground wire to the air conditioner
and replace the control panel and knobs. Remove
enough power cord to reach the wall outlet.