Energy Saver Fan
Cycle Switch
NORM
I
I
SAVE
ENERGY SAVER
This switch controls the
operation.
NORM setting allows continuous
function, circulating
even when
the compressor has cycled off
the
thermostat setting has been reached.
This setting is recommended
maximum comfort.
SAVE setting lets the
cycle on
with the compressor during
cooling. The fan stops when the
thermostat setting is satisfied. This
setting results in longer off time
wider variations room
temperature and humidity. This
setting is normally used when the
room is unoccupied.
OPEN VENT CLOSE
I
I
(ON THE LOWER RIGHT SIDE
OF THE DISCHARGE GRILLE)
Ventilation Control
When you move the Ventilation
Control to CLOSE, the vent door is
closed and only the air inside the
room will be circulated and
conditioned. Moving the control to
OPEN opens the vent door,
allowing a small amount of indoor
air to be exhausted from the room.
However, cooling effectiveness is
reduced when this control is set at
OPEN, so we suggest you don’t
keep it there
in
hot, humid weather.
For normal cooling
1.
Set the Selector Switch at HIGH
COOL.
2. Set the Thermostat Control at
the desired number (usually 5-7 is a
good starting position). room
temperature is not satisfactory after
a reasonable time, set the
Thermostat Control a higher
number
a cooler room or at a
lower number for a warmer room.
3. Set the Energy Saver Switch at
NORM position
continuous
operation or at SAVE position to
automatically cycle the fan on and
with the compressor.
4. Set the Ventilation Control at
CLOSE except for brief periods
when you want to exhaust room air
to the outside.
For maximum cooling
1. Set the Selector Switch at
HIGH COOL.
2. Turn the Thermostat Control
to
3. Set the Ventilation Control
CLOSE.
4. Set the Energy Saver Switch at
the NORM position.
For quieter operation
1.
Set the Selector Switch at LOW
COOL position.
2. Slide the Thermostat Control to
the desired number.
3. Set the Ventilation Control at
CLOSE.
4. Set the Energy Saver Switch at
NORM position.
Note: When the Energy Saver
Switch is at the SAVE position,
changes in the sound level may be
more noticeable than when it’s at
the NORM position.
For nighttime operation
During the cooler evening hours,
recommend that you set the
Switch at LOW COOL for quieter
operation and the Thermostat
Control at mid-range (5 or 6). Set
the Ventilation Control at CLOSE
and the Energy Saver Switch
NORM or SAVE position.
For extreme temperatures
For greatest economy and best
performance, we suggest you
set the Selector Switch HIGH
COOL in extremely hot weather.
To adjust air direction
Up and
down
UP-AND-DOWN
AIR DIRECTION
The up-and-down air direction
louvers are controlled by fingertip
pressure on the louvers. They
regulate air discharge upward,
downward, or straight out.
Side to side
Two separate banks of side-to-side
air direction louvers have separate
tabs to let you direct discharged air
to the right, to the left, or straight
out.
