12
Table B2: on page 18 provides a location for you to record the actual user names and codes of
each.
Primary User Code
Note
The primary user code can
not be deleted.
There is one
Primary User code
which allows you to perform all system operations and user
programming. Only the primary user code can program, change, or delete a regular user code
from the system and directly bypass sensors.
The default Primary User code is
. It is important that you change this default and log
the new code in Table B1 in Appendix B.
User Code
There are three
User codes
that can arm and disarm the system. If necessary, they can be
assigned to neighbors, baby-sitters, or repair persons for temporary use.
¾
To enter user programming mode:
1. Make sure the system is disarmed. Press . The panel will display
ENTER
CODE
FOR
SETTINGS
.
2. Enter the primary user code. The first menu item is displayed (
CODES
).
¾
To change the primary user code:
1. Press
once.
2. Press
to display the current primary user code.
3. Enter the desired primary user code and then press .
¾
To program/change user (2-4) code:
Note
The system will not accept
the same code for two differ-
ent user codes.
1. Press
once
and then until the desired user code is reached.
2. Press
to display the current user (2-4) code (if any).
3. Enter the desired user code and then press .
¾
To delete a user code:
1. Press
once
and then until you reach the desired code you want to delete.
2. Press
twice to erase the user code.
Setting the Time
Although the installer usually sets the time, the user can change or reset it when necessary. The
panel uses a 12-hour clock.
¾
To set the time:
1. Press ,
and
then
to display the time.
2. Enter the current time and press to select am or pm.
3. With the desired time displayed, press to accept.
Adjusting the Panel Beep Volume
This setting allows the user to adjust the panel’s status, auxiliary alarm, and arming level beep
volume. The volume can be set from 0 to 5, with 0 being the lowest volume (all alarms sound at
the loudest level).
¾
To set the volume:
1. Press
twice and then
to display the volume.
2. Enter desired volume level and press .
Version
This setting allows the user to display the version of panel software and hardware or DTIM software
and hardware that is currently installed.
