20
Problem
Possible Causes
What To Do
Temperature settings
The control has been
•
Press and hold the
Increase
▲
/ Decrease
▼
pads at the
in the display can only
set to use Celsius.
same time to switch to Fahrenheit settings.
be set between 16 and 31
“E1” appears
Filter needs to be cleaned.
•
Turn the air conditioner
OFF
and unplug it.
in the display
NOTE:
The air conditioner must be unplugged for the
automatic filter clean timer to reset. Clean the filter.
See the
Care and Cleaning
section. After cleaning,
replace the filter and plug the air conditioner back in.
“Ed” appears
Frost protect automatically
•
Turn the air conditioner off. Wait at least 3 minutes and
in the display
activated.
turn the air conditioner back on. If the code reappears,
call for service.
“En” appears
Pipe temperature sensor
•
Call for service.
in the display
failure.
“Er” appears
Room temperature sensor
•
Call for service.
in the display
failure.
Before you call for service…
Troubleshooting Tips.
■
You may hear a pinging noise caused by water
being picked up and thrown against the
condenser on rainy days or when the humidity
is high. This design feature helps remove
moisture and improve efficiency.
■
You may hear the thermostat click when the
compressor cycles on and off.
■
Water will collect in the base pan during high
humidity or on rainy days. The water may
overflow and drip from the outdoor side of
the unit.
■
The fan may run even when the compressor
does not.
Normal Operating Sounds
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Содержание AKL05
Страница 42: ...Notas Apoyo al consumidor Solucionar problemas Operación Seguridad Instalación 18 ...
Страница 45: ...21 Notas Apoyo al consumidor Solucionar problemas Operación Seguridad Instalación ...
Страница 46: ...22 Notas Apoyo al consumidor Solucionar problemas Operación Seguridad Instalación ...