Safety Instructions
Operating Instructions
Car
e and Cleaning
Installation Instructions
Tro
u
b
le
shooting Tips
Consumer S
uppor
t
GEAppliances.com
COOL MODE
Remote Control
1. Press
COOL
pad.
2. Press
LOW
or
HIGH
pads to set desired fan speed.
3. Press the
IN / DECREASE –
pads to set the
desired temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the
MODE
pad until the
COOL
indicator light is lit.
2. Press the
FAN
pad until
HIGH
or
LOW
indicator light
is lit for desired fan speed.
3. Press the
IN / DECREASE –
pads to set the
desired temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature.
The compressor will cycle on and off to keep the room
at the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler.
Set the thermostat at a higher number and the indoor air
will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to
COOL
, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
COOL
mode and
HIGH
fan with a middle set temperature.
For Maximum Cooling—
Select the
COOL
mode
and
HIGH
fan with a lower set temperature.
For Quieter and Nighttime Cooling—
Select the
COOL
mode and
LOW
fan with a middle set temperature.
NOTE: There will be a 3-minute delay between setting
changes such as COOL to OFF and back to COOL.
FAN
Use the
FAN
to provide air circulation and filtering without
cooling or heating. Since fan only settings do not provide
cooling or heating, a temperature setting will not be
displayed.
Remote Control
Press
FAN
pad. Press
LOW
or
HIGH
pads to set desired
fan speed.
Control Panel
Press the
MODE
pad until the
FAN
indicator light is lit
and the
LOW
or
HIGH
indicator light is lit for the desired
fan speed.
HEAT MODE
Remote Control
1. Press
HEAT
pad.
2. Press
LOW
or
HIGH
pads to set desired fan speed.
3. Press the
IN / DECREASE –
pads to set the
desired temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the
MODE
pad until the
HEAT
indicator light is lit.
2. Press the
FAN
pad until
HIGH
or
LOW
indicator light
is lit for desired fan speed.
3. Press the
IN / DECREASE –
pads to set the
desired temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature.
The compressor will cycle on and off to keep the room
at the set level of comfort. Set the thermostat at a higher
number and the indoor air will become warmer.
Set the thermostat at a lower number and the indoor air
will become cooler.
NOTE:
If the air conditioner is off and is then turned on
while set to
HEAT
, it will take approximately 3 minutes
for the compressor to start and heating to begin.
Heating Descriptions
For Normal Heating—
Select the
Heat
mode and
HIGH
fan with a middle set temperature.
For Maximum Heating—
Select the
HEAT
mode
and
HIGH
fan with a higher set temperature.
For Quieter and Nighttime Heating—
Select the
HEAT
mode and
LOW
fan with a middle set temperature.
NOTE: There will be a 3-minute delay between setting
changes such as HEAT to OFF and back to HEAT.
7
