ge.com
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
Cool Mode
Use the
Cool
mode with
HIGH (F3), MED (F2)
or
LOW (F1)
fan for cooling. Use the
INCREASE
▲
/
DECREASE
▼
pads to set the desired temperature
between 60°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to a
Cool
setting or if turned from a fan setting
to a
Cool
setting, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
Cool
mode and
HIGH (F3)
or
MED (F2)
fan with a middle set
temperature.
For Maximum Cooling—
Select the
Cool
mode
and
HIGH (F3)
fan with a lower set temperature.
For Quieter & Nighttime Cooling—
Select the
Cool
mode and
LOW (F1)
fan with a middle set
temperature.
NOTE:
If you switch from a
Cool
setting to
OFF
or to a fan
setting, wait at least 3 minutes before switching back to a
Cool
setting.
Fan Speed Mode
Use the fan at
HIGH (F3), MED (F2)
or
LOW (F1)
to
provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Vent Control
The vent control is located above the control
panels.
When set at
CLOSE
, only the air inside the room
will be circulated and conditioned. When set at
OPEN
, some inside air is exhausted outside.
To open the vent, pull the lever toward you.
To close it, push it in.
Air Direction—Side-to-Side
The side-to-side air direction is adjusted by moving
the lever to the left or right.
5
Air Direction—Up and Down
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. If the
Timer
feature was set, it will resume its countdown.
You may need to set a new time if desired.
Power Outage Recovery Feature