![background image](http://html1.mh-extra.com/html/ge/agm24dh/agm24dh_owners-manual-and-installation-instructions_4266756004.webp)
4
About the controls on the air conditioner.
Features and appearance may vary.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
■
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
■
The remote control signal has a range of
up to 21 feet.
■
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
■
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
Air Conditioner Controls
Controls
ON/OFF Pad
Turns air conditioner on and off.
TEMP/TIME Increase
▲
/Decrease
▼
Pads
Use to set temperature when in
COOL
mode
or the time when using the
TIMER
feature.
MODE
Use to set the air conditioner to
COOL,
ENERGY SAVER
or
FAN
mode.
FAN SPEED Pad
Use to set the fan speed to
LOW (F1),
MED (F2)
or
HIGH (F3).
TIMER Pad
ON—
When the air conditioner is off,
it can be set to automatically come on in
1 to 24 hours at its previous setting. Each
touch of the
Increase
▲
/Decrease
▼
pads
will set the timer in hours.
OFF—
When the air conditioner is on,
it can be set to automatically turn off in
1 to 24 hours. Each touch of the
Increase
▲
/
Decrease
▼
pads will set the timer in hours.
To cancel the timer,
press the
TIMER
pad
until the display time disappears.
Remote Control Signal Receiver
Display
Shows the set temperature or time remaining
on timer.
Remote Control
Remote Control
TIMER
FAN
ENERGY
SAVER
COOL
POWER
FAN
SPEED
TIMER
MODE
TEMP
TIME
POWER
TEMP/TIME
FAN SPEED
MODE
TIMER
Timer on
Cool on
Fan on
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. The
TIMER
feature
will reset to the original setting. You may need to set
a new time if desired.
Power Outage Recovery Feature
Lights next to
the touch pads
on the air
conditioner
control panel
indicate the
selected
settings.
Energy
saver on