![background image](http://html1.mh-extra.com/html/ge/aem24dx/aem24dx_owners-manual-and-installation-instructions_4183680013.webp)
13
7KURXJKWKH:DOO,QVWDOODWLRQ,QVWUXFWLRQV³2SWLRQDO
The case may be installed through-the-wall in
both existing and new construction.
Read completely, then follow step-by-step.
NOTE: Obtain all materials locally for mounting
the air conditioner through-the-wall.
IMPORTANT
Through-the-wall installation is not appropriate
LIDQ\RIWKHVLGHRUWRSORXYHUVLQWKHFDVHZLOO
be obstructed by the wall.
$OOVLGHDQGWRSORXYHUVLQWKHFDVHPXVWSURMHFW
on the outdoor side of the wall.
The room side of the case must project
into the room far enough to maximize the
balance of the unit.
7KHFDVHPXVWEHLQVWDOOHGOHYHOIURPVLGHWR
side and with a slight tilt from front to rear. Use
DOHYHOQRPRUHWKDQDEXEEOHZLOOEHWKH
correct case slant to the outside.
/LQWHODQJOHLVUHTXLUHGWRVXSSRUWEULFNVRU
EORFNVDERYHRSHQLQJ
)ODVKLQJLVUHTXLUHGDQGVKRXOGH[WHQGWKH
OHQJWKRIWKHRSHQLQJWRHQVXUHQRLQVLGHFDYLW\
OHDNDJHRFFXUV
Remove the air conditioner from the case.
For specific instruction, refer to the Window
Installation Instructions.
Make certain that a wall receptacle is
available close to the hole location or make
arrangements to install a receptacle.
Place the case in the wall opening and
place wood support strips between the case
bottom and the flashing on both sides of the
bottom rail. They should be the same height as
the bottom rail and the same length as the wall
opening.
1
A
B
FINISH THE WALL OPENING
Caulk all four sides on the outdoor side of the
case to prevent moisture from getting through
to the interior wall. Use of flashing (drip rail) will
further prevent water from dripping inside the
wall and down the outside of the building.
Place the air conditioner into the case.
For specific instruction, refer to the Window
Installation Instructions.
2
IMPORTANT
(cont.)
Secure with 14 wood screws anchored at least an
inch into the wall support structure.
NOTE:
Drill pilot holes, if necessary, for proper
installation. If the frame is oversized, use shims to
prevent case distortion.
1
D
A
B
Lintel angle
Plaster line
Trim molding (if
desired)
INSIDE
Bottom rail
Wood filler and
caulking (above and
below the flashing)
Air louvers (top
and sides must
project on the
outdoor side of
the wall)
OUTSIDE
Flashing
(Drip rail)
Case
bottom
Bottom
rail
Flashing
(Drip rail)
Wood support strips
Caulking
C
Содержание AEM24DX
Страница 16: ...16 Notes...
Страница 47: ...47 Notas GEAppliances com...
Страница 48: ...48 Notas...
Страница 49: ...49 Notas GEAppliances com...