Problem
Possible Causes
What To Do
Display flashes “bAd”
The installed connection
•
Contact installer or electrician to correct miswire.
then “linE” with a
from the house to the unit
loud tone
is miswired.
Control signals after
You forgot to enter a
•
Touch the
BAKE
pad and desired temperature or
entering cooking time
bake temperature or
the
SELF CLEAN
pad and desired clean time.
or start time
cleaning time.
Display goes blank
A fuse in your home may
•
Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
The clock is in
•
See the
Using the clock and timer
section.
black-out mode.
Display flashes
Power failure.
•
Reset the clock.
Unable to get the
Oven control pads were
•
The
BROIL HI/LO
and
BAKE
pads must be touched at
display to show “SF”
not touched properly.
the same time and held for 3 seconds.
Power outage,
Power outage or surge.
•
Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the
CLEAR/OFF
pad, setting the clock
and resetting any cooking function.
“Burning” or “oily”
This is normal in a new oven
•
To speed the process, set a self-clean cycle for a
odor emitting from
and will disappear in time.
minimum of 3 hours. See the
Using the self-cleaning
the vent
oven section.
Strong odor
An odor from the insulation
•
This is temporary.
around the inside of the oven
is normal for the first few
times the oven is used.
Fan noise
A cooling fan may
•
This is normal. The cooling fan will turn off and on
automatically turn
to cool internal parts. It may run after the oven is
on and off.
turned OFF.
30
Consumer Support
Tr
oubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Before you call for service…
Troubleshooting Tips
Содержание 49-80535-1
Страница 32: ...32 ...