The sensitivity of sound trigger can be adjusted by turning the knob “sensitivity adjust
tuner.
Operating Modes///
The wireless system can be set to operate in one of three modes: Scan, Auto or
Manual. The desired operating mode can be selected using the buttons on the front
panel of the LCD monitor.
Scan
Pressing the Scan button places the system in Scan mode. The LCD monitor screen
blanks into a standby mode while the system continuously scans the active cameras. If
a camera detects motion, the LCD monitor displays the camera picture and the beeper
will sound. Several minutes after the last detection, the screen returns to standby
mode while the LCD monitor resumes scanning. Pressing the Manual or Auto button
will wake up the LCD.
Auto
Pressing the Auto button places the system in Auto mode. In this mode, the system
automatically circulate through all active cameras. When a camera detects sound is
too high(you can set the compared sound by the sensitivity knob), the LCD monitor
will display the picture from the camera for a few seconds, and the beeper will sound.
To avoid searching channels that do not have cameras/transmitters assigned to them,
set the DIP switches(inside the battery compartment) for those corresponding
channels to the off position. The dwell time(time taken to switch between cameras) is
preset to 4 seconds and can be adjusted between 2 - 30 seconds. To adjust the dwell
time, press both the Auto and Manual buttons simultaneously. Each flash of the LED
in-creases the dwell time by one second.
Manual
To select a specific camera to LCD monitor, press the Manual button. The LCD
Содержание 45236
Страница 1: ......
