13
Using Your Remote, cont.
3. Press and release the
MUTE button.
4. Press and release the
VOL - button.
The red indicator light will blink twice
and go off.
Code Identification
1. Press and hold the
SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the desired device
button (
TV, CBL, DVR, B-RAY, SAT,
AMP, AUX 1, AUX 2) you would like the
code for.
3. Press and release
ENTER button.
4. Press and release the
#1 button.
Count the number of times the
remote light flashes. This is the
number corresponding to the first
digit of the code. Repeat the process
by pressing the
#2, #3 and #4
buttons for the remaining digits.
5. Press and release
ENTER button to
exit this mode.
Reset to Factory Settings
1. Press and hold the
SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the
MUTE button.
3. Press and release the number
#0
button. The red indicator light will
flash twice.
setup
cbl
setup
8
9
4
5
6
1
2
3
7
0
0