14
General Product Care
Simply wipe the base station with a damp cloth or an antistatic wipe.
Never use a dry cloth as this can cause static discharge.
Troubleshooting Guide
When you forget base PIN, following the procedure to Reset the units.
ALL MEMORY AND SETTING WILL BE LOST.
Refer to handset – Call Log Operation procedure, select
DELETE ALL
to delete all Call Log Memories in handset.
Disconnect the line cord and AC power supply.
Hold “PAGE” button and plug in the AC power supply.
When a Beep tone heard and in-use LED turns On, release
“PAGE” button. Press “PAGE” button three times again.
The In-Use LED will turn Off.
The unit will return to its default setting a PIN code (0000).
Unplug AC power of base station and plug in again, handset
LCD will display “ ---- ”.
Following “Registering Additional Handsets” to register all
handsets again.
PROBLEMS CAUSES SOLUTIONS
The battery is not
sufficiently charged.
Charge the battery
for 14 hours.
Registration not
work.
Handset and base
station were not
prepare for
registration.
Unplug and then
plug in the power
adaptor.
No display.
The battery has not
been charged.
Charge the battery or
replace them.
No reactions to
keystroke.
The keypad is
locked.
Press * key longer
than 2 seconds.
The handset is
outside the base
station range.
Move closer to the
base station.
The handset is not
registered.
Register the handset
(see Registering
Handset).
No radio connection
to the base station:
blinking!
The base station
does not work.
Unplug and then
plug the power
adaptor to the power
outlet (220-230V AC
/ 50 Hz) and the
other end into the
power jack on base
bottom.
Environment
Used equipment and used handset batteries must be disposed of in
compliance with current environmental protection regulations. You
should return them to your reseller or dispose of them at an approved
recycling centre.
Do not attempt to open the batteries, as they contain chemical
substance. In the event of leakage, avoid contact with the skin, eyes
and mouth. In the event of contact, rinse the affected part for several
minutes in running water. Clean the product with absorbent paper or
a dry cloth and contact your reseller for replacement batteries.
