AMX−4+ OPERATION
GE MEDICAL SYSTEMS
(MODEL 2169360, 2236420 & 2275938 SERIES)
REV 10
om 2166913−100
iii
REGULATORY REQUIREMENTS
This product conforms with the requirements of Council Directive 93/42/EEC concerning medical
devices when it bears the following CE marking of conformity:
0459
Note
:
This equipment generates, uses, and can radiate radio frequency energy. The
equipment may cause radio frequency interference to other medical and
non-medical devices and radio communications. To provide reasonable protection
against such interference, the AMX4+ Mobile X−Ray Unit complies with emissions
limits for a Group 1, Class A Medical Devices as stated in EN 60601−1−2.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment is found to cause interference (which may be
determined by switching the equipment on and off), the user (or qualified service
personnel) should attempt to correct the problem by one or more of the following
measure(s):
D
Reorient or relocate the affected device(s).
D
Increase the separating space between the equipment and the affected device.
D
Power the equipment from a source different from that of the affected device.
D
Consult the point of purchase or service representative for further suggestions.
The manufacturer is not responsible for any interference caused either by the use of
interconnect cables other than those recommended, or by unauthorized changes
or modifications to this equipment. Unauthorized changes or modifications could
void the user’s authority to operate the equipment.
To comply with the regulations applicable to an electromagnetic interface for a
Group 1, Class A Medical Device, all interconnect cables to peripheral devices must
be shielded and properly grounded. Use of cables not properly shielded and
grounded may result in the equipment causing radio frequency interference in
violation of the European Union Medical Device directive and FCC regulations.
Setting for Mobile AID
Under certain Electro Static Discharge (ESD) conditions, the optional Automatic Exposure Control
for the AMX 4+ may self−modify its settings. The operator will need to adjust the settings to their
original condition. If the problem cannot be corrected, please call service.
FOR
TRAINING
PURPOSES
ONLY!
NOTE:
Once
downloaded,
this
document
is
UNCONTROLLED,
and
therefore
may
not
be
the
latest
revision.
Always
confirm
revision
status
against
a
validated
source
(ie
CDL).
