2.2.8
Snmp
command group
The
snmp
command group allows to configure the SNMP Agent for UPS monitoring via SNMP and trap
notification of UPS events and alarms:
Command Parameters Description
showsnmp
Show detailed system information
snmpport
[port]
Set SNMP server listening port (*)
[port]
SNMP
port
NOTE
:
Default SNMP port is 161.
snmp-server
on | off
Enable/disable SNMP Agent
on
SNMP Agent enabled
o
ff
SNMP Agent disabled
syscontact
[contact] (**)
Set the system contact
[contact]
contact
person
NOTE
:
The
syscontact
parameter is the identification of
the contact person for the managed node.
syslocation
[location] (**)
Set the system location
[location]
location
name
NOTE
:
The
syslocation
parameter is the identification of
the physical location of the managed node.
Defines the community name for receiving SNMP
information (GET).
[community] community
name
[community]
getcommunity
NOTE
:
The get community name controls access to the
SNMP Agent – the community in the request must match
the
getcommunity
parameter.
The default value is
public
.
Defines the community name for writing SNMP
information (SET).
[community] community
name
NOTE
:
The set community name controls access to the
SNMP Agent – the community in the request must match
the
setcommunity
parameter.
The default value is
private
.
setcommunity
[community]
(*) Changing the port causes the SNMP Agent to restart. This might have a temporary effect also on trap
notification.
(**) Both parameters have a maximum length of 63 chars. If these parameters contain blanks or special
characters they shall be specified in between double quotation marks (“...”) .
Modifications reserved
Page 21/58
OPM_CNT_SNM_BAS_CRD_1GB_V012.doc
Operating Manual
SNMP/Web Adapter
