GE Security Simon XT, Руководство пользователя

Страница: 36 / 60

Simon XT
User Manual
30
System programming
To enter system programming mode, do the following:
1. Press the scroll buttons until the panel displays System programming .
2. Press Enter . The system prompts for an access code.
3. Enter your master code. The system displays each entered access code digit as an asterisk.
4. Press Enter . The panel is now in program mode.
At this point, you are in the System programming submenu. At this level, the following items are accessible:
• Access codes
• Security on page 31
• Phone numbers on page 32
• Timers on page 32
• System options on page 33
• Siren options on page 34
• Light control on page 36
• Ethernet configuration on page 37
• GSM configuration on page 37
• System tests
The following sections describe the options that you can program in the System programming menu.
Access codes
There are three types of access codes: master, user, and duress.
Master code. The master code is your most powerful code and can be used for all user operations
including programming. To change the master code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes , then press Enter .
3. Scroll up/down to Master code , then press Enter .
4. A flashing cursor is now displayed.
5. Enter a new code (use correct length), then press Enter .
6. Press Status repeatedly to exit.
The initial value of the master code is 123, 1234, 12345, or 123456, depending on the installer-
programmed access code length.
User codes 1 to 8. There are eight user codes, which can be used for many user operations, but not
subdisarming, programming, or bypassing sensors.
To change a user code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes , then press Enter .