GE HEALTHCARE MAC 5500, Руководство оператора

Страница: 151 / 188

System Setup
Setting Up a Bar Code Reader
This section describes two methods for configuring the bar code reader:
• Automatic Configuration
• Manual Configuration
NOTE:
When configured for a bar code reader, the system will prompt you to scan
the patient ID bar code when you select Patient Information. If no bar code is
available, press
esc to enter the patient information manually.
Do not use the bar code reader for scanning the bar code that appears on the ECG
printout: that bar code format is not supported by the bar code reader.
Automatic Configuration
Use the following procedure to automatically configure your bar code reader.
1. Obtain a configuration bar code.
For information on creating patient bar codes, refer to Appendix E , “Creating Bar
Codes and Magnetic Cards” .
2. Connect the bar code reader to port A on the back of the system.
3. From the Main Menu , select System Setup > Basic System > Input Method
Select > Patient Data Input Device > Bar Code Reader > Return .
4. When the Manual Bar Code Reader Configuration window opens, press esc .
5. When the Basic System menu opens, press esc .
6. Select Save Setup > To System .
7. Restart the device.
8. From the Main Menu , select System Setup > Basic System > Input Method
Select > Bar Code Reader Configuration > Automatic > Return .
The following message is displayed:
Scan the Configuration Bar Card
9. Scan the bar code.
The Manual Bar Code Reader Configuration window opens with the values
filled in.
10. Press esc twice.
11. Select Save Setup > To System .
Manual Configuration
Use the following procedure to manually configure your bar code reader.
1. Connect the bar code reader to port A on the back of the system.
2. From the Main Menu , select System Setup > Basic System > Input Method
Select > Patient Data Input Device > Bar Code Reader > Return .
The Manual Bar Code Reader Configuration window opens.
2046275-016B
MAC ® 5500/MAC ® 5500 HD
151