TEST GAS KIT – PART No 99-0010 / 99-0020
110 LT GAS CAPACITY (1.6LT WATER CAPACITY) –
FIXED FLOW REGULATOR
•
Ensure regulator control knob is closed (clockwise) before use.
•
Screw onto outlet of the can until it stops and pressure registers
on the gauge.
•
The regulator may now be opened by turning the control knob
anti-clockwise. Gas will now be delivered at a pre-set flow rate.
•
Always remove regulators after use. All cans will re-seal upon
removal, there may be a “hiss” of gas when removal takes place.
•
Attach the test gas applicator attachment to one end of the plastic
sample pipe.
•
Connect the other end of the sample pipe to the output nozzle
of the regulator.
•
Turn the regulator adjuster anti-clockwise until a flow of gas is
obtained from the sample pipe.
•
Screw the test gas applicator onto the sensor.
•
When the gas monitor meter reading has achieved a maximum
steady reading adjust the calibration potentiometer
for the required meter reading.
•
Remove the test gas applicator and allow the meter to return to zero.