Page
16
of 37
HES7000 ICL
I User’s Guide A01583 Rev. A
Mode
Parent
Mode
Description
MPLS-TP Global
Config
Config
Sub-mode for configuring global MPLS-TP parameters
Command:
mpls tp
Prompt:
hostname
(config-mpls-tp)#
MPLS-TP CoS
Map Config
Config
Sub-mode for configuring MPLS-TP CoS maps
Command:
mpls tp cos-map
cos_map_number
Prompt:
hostname
(config-mpls-tp-cos-map)#
MPLS-TP LSP
Config
Config
Sub-mode for configuring MPLS-TP LSPs
Command:
mpls tp lsp
lsp_number
Prompt:
hostname
(config-mpls-tp-lsp)#
MPLS Pseudo
Wire Config
Config
Sub-mode for configuring MPLS pseudo wires (PWs)
Command:
mpls pw
pw_number
Prompt:
hostname
(config-mpls-pw)#
MPLS-TP Tunnel
Interface Config
Config
Sub-mode for configuring MPLS-TP tunnel interfaces
Command:
interface tunnel-tp
tunnel_number
Prompt:
hostname
(config-if-ttp)#
Y.1564 Config
Config
Sub-mode for configuring Y.1564 profiles
Command:
y1564 profile
profile_name
Prompt:
hostname
(config-y1564-profile)#
JSON Notification
Host Config
Config
Sub-mode for configuring JSON notification hosts
Command:
json notification host
host_name
Prompt:
hostname
(config-json-notif-host)#
It is possible for a user to transition between these modes using certain commands, subject
to the user’s privilege level and the current session privilege level (see section 3.6).
The initial mode is determined by the privilege level of the user logging in. If the privilege
level is zero or one, the user is
unprivileged
and begins in the (Unprivileged) Exec mode. If
the privilege level is higher, the session begins in Privileged Exec mode.
A user can raise the Exec mode privilege level to a higher value if an
enable password
has
been configured for that level. This elevation is done with the
enable
level
command, where
level is a value between 1 and 15. The reverse operation, lowering the privilege level, is
achieved with the
disable
command.
Once in Privileged Exec mode it is possible to enter into the Global Configuration mode by
entering the command,
configure terminal
. Exit from Global Configuration is achieved with
one of
end
,
exit
or
Ctrl-Z
.
Access to a configuration sub-mode (e.g., for Ethernet interfaces) goes through Global
Configuration or another sub-mode. Thus it is possible to change directly from, say, VLAN
sub-mode to Ethernet interface sub-mode.
Each mode and sub-mode thus implements a
scope
for commands: Inside each mode a
particular subset of commands is available. To get to other commands one must generally
change mode/sub-mode. This is necessary because there are commands with identical
prefixes in different modes. For example there are
commands that begin with ‘ip’ in
Privileged Exec, Global Configuration and VLAN Interface Configuration modes.
Содержание HES7000
Страница 1: ...HES7000 ICLI USER S GUIDE A01583 Rev A ...
Страница 3: ...HES7000 ICLI User s Guide A01583 Rev A ...
Страница 4: ......
