GCX RS-0006-64 Скачать руководство пользователя страница 5

Страница: 5 / 5

DU-RS-0006-64 Rev B 3/28/14 GCX Corp Page 5 of 5

Adjusting Swivel and Tilt Tension on the Tilt/Swivel Mounting Plate

Adjust

Swivel tension

by tightening or loosening the socket set screw on the side of the Roll Stand Post (below left). A

2.5mm hex wrench is provided for this adjustment.

Adjust

Tilt tension

by tightening or loosening the socket set screw on the top of the Roll Stand Post (below right). A 5/32''

hex wrench is provided for this adjustment.

Cable Managment

Two (2) Cable Clips are provided for managing cables along Roll Stand Post. Place loose cables inside Clip and slide Clip
onto Post as shown.

Routine Maintenance

Periodically inspect all fasteners associated with the mounting system. Tighten as necessary for optimal operation and
safety.

Cleaning the Mounting Assembly

1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital

environment (e.g. diluted bleach, ammonia, or alcohol solutions).

2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone and

trichloroethylene.

3. Do not use steel wool or other abrasive material to clean the mounting assembly.

4. Damage caused by the use of unapproved substances or processes will not be covered by warranty. We

recommended that you test any cleaning solution on a small area of the mounting assembly that is not visible to verify
compatibility.

5. Never submerge the roll stand or allow liquids to enter the mounting assemblies. Wipe any cleaning agents off the

mounting assembly immediately using a water-dampened cloth. Dry all mounting assemblies thoroughly after cleaning.

CAUTION:

GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling

infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize mounted instruments or

accessory equipment, refer to the specific instructions delivered with those products.

Cable Clip

bles

Slide onto Post

Swivel Tension Adjustment

Tilt Tension Adjustment

Cable Clip

Содержание RS-0006-64





