AquaBead
AlphaONE
PLUS
System Instructions
Congratulations
on your new
AquaBead/AlphaONE
PLUS
System
Your filter system was designed to go together easily even for a
novice. Each of the components was carefully chosen to provide you with
years of dependable service and clear water for you and your pond.
Take a few minutes to look at this manual and familiarize yourself
with each of the components and what part they play in the PLUS system.
Due to the custom nature of these systems your components may
differ slightly from the various components shown, but assembly of the
system is basically the same.
You have with this system the following components:
AquaSieve
(optional) prefilter
AquaBead/AlphaONE
bio-mechanical filter
Water pump (can be one of a variety)
Zapp Pure
Ultraviolet light
Plumbing parts
Black equipment pad(s)
Getting to know your
AquaBead/
AlphaONE
PLUS
System
Taking a few minutes to get to know the
different components of your Aqua-
Bead/AlphaONE Plus System will as-
sure that you are using it to it’s maxi-
mum potential.
AquaSieve
Prefilter
(optional)
AquaBead/
AlphaONE
Filter
Zapp Pure
High Intensity UV
Water pump
(Various)
2 speed shown
Assembly of your
AquaBead/AlphaONE PLUS
System
Step 1: Start by laying the Pad(s) on level ground where you want to
locate the equipment.
Note: Locating the equipment as close as possible or below the surface grade(water
level) of the pond will result in best results. Distance from the pond is not as critical as
the distance above the surface grade.
Follow the numbers and assemble according to number. Connect like
“number to like number”. Each piece of plumbing is marked with a
number such as 1-1, 2-2, 3-3, etc.
Step 2: If your system is
equipped with an Aqua-
Sieve position it to the
far left where the filter is
shown sitting in this
photo with the filter sit-
ting to the right(See
cover picture). If not
equipped with an Aqua-
Sieve, place the filter to
the left side of the pad.
If you need any help
feel free to give us a
call 866.712.7007
