
QUICK START INSTRUCTIONS
Q.S.I. HLF 5700 Eng V06-2021 HLF Italian Design
1.2
Procedure
1.2.1
Minimum Requirements
The machine must only be installed using the supplied connection cables and hoses.
Any existing cables or hoses must not be reused. The manufacturer is not liable for any
damages arising from improper installation.
The use of incorrect connections voids the warranty!
Water Requirements:
flow rate of at least 3 L/min.
For example:
Fill a container of 3 Liter capacious and make sure the time it takes to be filled in is 60
seconds or less (or 1 Liter in 20 seconds or less).
The maximum pressure of the water line has to be between 1 to 6 bar.
Electric Requirements
: Be sure to choose a wall plug with enough power to supply the
unit and tha
t it’s grounded in observance with current safety norms.
Refer to paragraph 1.3.3 of this Instruction Manual to select the correct wall plug.
1.2.2
Water connection
On the back of the HLF 5700 is located the inlet water valve that permits the connection
of the machine to the direct water line.
CAUTION
The water connection must only be connected to drinking water.
The maximum pressure of the water line has to be between 1 to 6 bar in order to
prevent damages to the inlet water valve. A lower pressure will not be sufficient to open
the inlet water valve, meanwhile a higher pressure will brake the valve causing in this
way a water flood.
Refer to the national laws of your country for the connection to the water line.
To connect the water line to the HLF 5700, is necessary to use a tube with a female
screw of ¾ of inch at each end of it, as showed on the following picture.