GCC Technologies Jaguar IV Series, Руководство по обслуживанию

Страница: 57 / 68

57
4.1.5 Diagnostic Test for Width Sensor
If the sensor is faulty, the cutter cannot sense the media width correctly. Refer to the maintenance chapter to replace it. You
must first move the tool carriage to the rightmost position; the lever must be down to do this. Once this is done please move
the tool carriage to left. Be careful when moving the tool carriage close to the pinch roller, since the message changes
quickly when sensor is between on and off.
Check Width Sensor ?
Enter Key
Move Carriage
To Rightmost
delay 3 seconds
delay 3 seconds
No
Lever up or not?
Now Lever is Up
Lower the lever
Yes
Move Carriage Slowly
To Left Hard Stop
Pinch Roller Sensor
No Yes
on or not?
Now Sensor is off
Move Carriage Slowly
Now Sensor is On
Move Carriage Slowly