3
Elite XL Sheet Feeder Installation Guide
Installation procedure
Note: Steps marked
16ppm
are only applicable to 16 page-per-minute Elite XL
models.
To add one or two sheet feeder(s) to the Elite XL printer:
1.
Switch off the printer and unplug the power cord from the AC outlet.
2.
Disconnect the power cord and all interface cables from the back of the
printer.
3.
Remove any paper tray(s) from the printer.
16ppm
4.
If there is a 500-sheet feeder attached to the printer, you must remove it
before attaching the 250-sheet feeder. (See “Removal Procedure” on
page 10). Reminder: You may not attach two 500-sheet feeders to the
printer.
5.
Unpack the sheet feeder(s) and place on a flat surface.
16ppm
5a. If there are two sheet feeders, attach the two feeders together. Lower
the 250-sheet feeder onto the 500-sheet feeder or the other 250-sheet feeder.
The sheet feeders have four pins that enable proper alignment.
16ppm
5b. Attach four retaining clips.
Use four of the plastic retaining clips to lock the feeders together.
The clips fit into slots located at the four corners where the sheet feeders
mate.
alignment pin
