GBS Elettronica LCD-104, Руководство по установке

Страница: 2 / 12

1. Determine the proper length of bolt for attaching the mount to your display by examin-
ing the back of the display:
1. To complete the installation, simply slide the mount with your LCD attached into the
wall piece. The plastic tab at the top of wall piece should click indicating that the mount
is secure.
2. To remove the mount, push in on the plastic tab and then slide the mount up.
3. For additional security and stability, tighten the set screw located on the base of the arm
piece using the 3 mm Allen Key (
M
) supplied in the hardware kit.
4. Use the cable management hook (see illustration) to keep the power cord and other
cables for your display in order while adjusting the mount.
5. To change the tilt angle, hold the display with one hand and loosen the tilt adjustment
knob. Move the display to the desired position and re-tighten the knob. Other adjust-
ments can be made by simple moving the mount into the desired position.
6. If you find that a joint is too difficult to move or has become too loose, you can adjust
the tightness of that joint using the 4 mm Allen Key (
N
) supplied in the hardware kit.
2. Attach the mount to your display using the hardware determined in Step 1 (see illustra-
tion). To avoid damage to your display, do not over-tighten these bolts.
a) If your display has a flat back, you will use one of the shorter bolts from the
hardware kit (C, E, G or H). Carefully test each of the shorter bolts with your display
to determine the correct diameter to use.
b) If the back of your display is curved or recessed, or if there are any obstructions
preventing the mount from resting flat against the back, you will use one of the
longer bolts (D, F, H or J) along with a spacer (L). Carefully test each of the longer
bolts with your display to determine the correct diameter to use.
Part 2 - Attach the Mount To Your Display
Part 3 - Slide the Pieces Together
Spacer (
L
)
Only if using
D, F, H or J
Bolt (
C, D, E, F, G, H, I or J
)