1. Installation
* For your convenience, perform the initial configuration of the doorbell
connecting it to a power supply nearby the user’s home internet router. From
this way, it is possible to check the full operational function before place the
parts of the product.
-
Placing the outdoor station:
Place the outdoor station beside
your gate, considering field of vision, shadows and background light
(for the camera).
You should also consider proximity of AC power and
the ability to wire for additional accessories. The recommended mount
height is 60” (150cm) above the surface where the caller is standing
on. At the chosen place must have at least a 1 ¼” hole on the wall to
allow the wired connection.
-
Placing the Skybox:
Place the Skybox in a local with good wi-fi
connection with the user’s router or in a local with access of a ethernet
cable from the user’s router. Remember about the necessary power
supply.
-
Connecting the system:
Using the four wires connectors (come
jointly the kit), connect the outdoor station with each corresponding
skybox. Notice that there is a 4-pin connector for each unit inside the
outdoor station (CN1, CN2, CN3, CN4, etc.) and two behind skybox,
the first outdoor station must be connected at the CN1 port of the
corresponding skybox, and the same step must be used for the
subsequent units. Notice that the connectors already come prepared
to be extended, only make sure to match the wires post extension by
the color code.
-
Connecting an electric lock:
The outdoor station possesses a
SPDT relay that allows the use of an electric lock with a push-button to
release the gate. Use the red and black wires from the 5-pins
connector (CN5 behind the outdoor station) to connect a push-bottom.
Use the green and blue wires for normal opened contact, or blue and
brown for the normal closed contact, to connect the electric lock.
-
Powering the system:
Connect the power supplies to the 2-pins
connectors on each system’s part (outdoor station and skybox).
