GBC StreamWire, Руководство по обслуживанию

Страница: 113 / 455

Repairs/Adjustments 07/23/2020 GBC StreamWire
4-16
REP 2.4 Idler Roller Replacement, Paper Path
PARTS LIST ON PL 5.5
Use this procedure to remove and install the Idler Rollers on the following
Nips:
N1 - N2, and N5-17
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.1
Top Cover Replacement to remove the Top Cover.
4. For Rollers on Nip N7 only, raise the Lower Bypass Panel. The idler
roller is located on the surface of the curved plate under the panel.
5. Lift the Extension Spring (2) up off the Bearing Housing (2) at each
end of the Idler Roller Shaft. Unhook the ends of the extension
spring from the Bushing Forks.
6. Remove the Idler Roller with the Bearing Housings (2) from the
Bushing Forks.
Installation Procedure
1. Place the new Idler Roller with Bearing Housings into the Bushing
Forks.
2. Make sure the flat surface of the bushing aligns in the fork.
3. Rollers are non-directional so it does not matter which end goes in
each fork.
4. After the assembly is in place, gently pull the assembly outward and
release to ensure it moves freely in the fork.
5. Place the Extension Spring (2) over the Bearing Housings (2).
6. Place the hooks on the ends of the Extension Springs (2) on the
notches at the top of the Bushing Forks (2).
7. Do REP 1.1 Top Cover Replacement to install the Top Cover.
8. Connect the Power Cord.
9. Power ON the eWire.