GBC OORCA-III, Руководство по эксплуатации

Страница: 16 / 109

ORCA-III Operation Manual Installation

GBC Pro-Tech 1997 October
2-5
WARNING
Do not attempt to move the laminator across
anything other than a flat, level surface
without trained and qualified riggers. You can
be crushed or seriously injured.
The ORCA-III Laminator is a large and
heavy piece of equipment. It is necessary to
employ LICENSED RIGGERS ONLY to
move the machine. The laminator is not
designed to be tipped up or sideways in any
way. Such action disturbs the exact alignment
of the rolling parts of the machine and
requires extensive realignment. GBC Pro-
Tech’s warranty does not cover malfunction of
the equipment due to mishandling and/or
tipping.
GBC Pro-Tech bears no responsibility for
personal injury or damage due to moving the
laminator improperly.
5. Remove any plastic strapping and packing paper
taped to the
roll
s.
CAUTION
Do not use a knife or other sharp instrument
during installation or while servicing the
laminator. You can cause irreparable damage
to the rolls.
6. Remove all packing materials to a safe distance
from the laminator.
⇒
A NOTE ABOUT RECYCLING
The crate components can be reused for shipping
the machine again, or can be disassembled and the
wood and screws recycled. The shrink wrap is not
recyclable, however, so it must be discarded.
⇒
NOTE
A word about international shipments: As these are
heavy pieces of equipment, GBC Pro-Tech takes
every precaution to ensure that our laminators are
properly crated to the highest standards.
Before machines leave our loading dock, they are
pre-treated with a VCI protective film to provide
total corrosion protection. This protective film is
wrapped around the machine and completely sealed.
In addition, moisture absorbing silicone desiccite
packs are packed inside the crate and machine
cabinets.
Prior to start up of the machine, you must remove
the desiccite packs from each cabinet and discard.
DO NOT operate the machine with the desiccite
packs inside the cabinets
7. Level the laminator using the procedure later in
this section.
6HWXS
Once the ORCA-III Laminator has been unpacked
and moved into final position check each of the
following items.
Tools required:
•
1
/
8
" hex wrench
•
Adjustable wrench
Setup Procedure
1. Inspect the laminator for any obvious shipping
damage.
2. Open the left and right side cabinet covers with
the
5
/
32
" hex wrench by removing the four screws
holding each cover in place.
3. Inspect all the bolts and tighten any that were
loosened during shipping.
4. Have a certified electrician wire the laminator
directly to a power source.
5. Set the nip. (See Maintenance for the procedure.)
6. Verify that the infrared sensors are not blocked.
WARNING
NEVER BLOCK THE INFRARED
SENSORS! The rolls can overheat and cause
a fire or seriously damage the laminator.