GBC GBC Proclick Pronto, Техническое и сервисное руководство

Страница: 18 / 92

18
6.0 DISASSEMBLY / ASSEMBLY / ADJUSTMENTS
CAUTION: Before performing any service on the unit, unplug the power cord to
avoid possible serious electrical shock. If it is necessary to run the machine with the
covers removed, use caution to avoid contact with electrical components.
NECESSARY TOOLS:
1. Phillips Screwdriver #1 Tip
2. Phillips Screwdriver #2 Tip
3. Flat Blade Screwdriver #1 Tip
4. Flat Blade Screwdriver #2 Tip
5. Nut Driver
6. Open End / Box End Wrench
7. Hex Key Wrench
8. Needle Nose Pliers
9. Wire Cutters
10. Supply of Wire Tie Wraps
11. Volt/Ohm Multi Meter
REMOVING THE COVERS:
Refer to the Video entitled “Removing the Covers” as you review the following text
• There are 5 covers to be removed to service the machine, they must be
removed in order.
• There are 6 screws to remove the front cover.
• There are 8 screws to remove the back cover.
• There are 4 screws to remove the PC board cover.
• Do not remove the PC board cover as there are wires attached.
• There are 3 screws to remove on each of the side covers.
• There are 4 screws to remove the LED Screen.
NOTE: The covers must be removed in order.
CHANGING THE DIE:
Refer to the Video entitled “Changing the Die” as you review the following text.
• Remove the 2 screws on the left grid bracket.
• Remove the 1 top side screw on the right grid bracket.
• Loosen the bottom side screw, located under the right grid bracket.
• You would need to remove the chip tray and slide the unit to the edge of the
table to access the screw.
• Remove the screw for the support bar on the left grid bracket.
• Remove the left and right grid brackets and replace the die.
• Follow the procedure in reverse to return to operation.
NOTE: Before removing the die, take note of which hole in the die the gear tooth is
in. When replacing the die, the gear tooth should be in the same position before
tightening.