GB
6
register this product online at www.accoeurope.com
getting ready to laminate
Easy Set Up
1
Remove the plastic exit tray from the box and place into the two holes on the back of the
laminator and extend to use. Ensure that there is sufficient space behind the laminator for the
item to be removed.
2
Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
3
The laminator will briefly flash the GBC logo on the control panel and will make an audible beep.
4
To use the laminator gently tap the ‘power on’ button.
NOTE: Your new laminator may emit
a slight odour during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
Manual Select ( ) – scroll through and select the required micron setting, i.e. 75mic.
NOTE: If 40mic setting is selected
ALWAYS use a carrier
mic
40
mic
75
mic
125
mic
175
mic
250
Interactive Menu Selection
5
A GBC logo will show in the screen followed by the main menu:
MANUAL SELECT
AUTO POUCH SELECT
SETTINGS
HELP
NOTE: Use arrows to scroll up/down and left/right, use ENTER button
to select.
Use at anytime to go back – one screen at a - time to the main
menu.
