Page 5 - 5
Operations
F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
( 19 ) SAVE : When pressed and held ( approximately 4
seconds ), will beep and save the current settings for the
number showing in the JOB DISPLAY. For more
information, refer to Section 5.4 Job Programming on
how to save parameters.
J O B
STANDBY
SEL
S A V
9
19
( 20 ) SPEED DISPLAY : Displays the current speed
setting of the laminator.
S P E E D
SAFETY
F W D
R E V
00.0
S T O P
G O
20
( 21 ) SPEED
▲
: When pressed, increases the speed of
the laminator in increments of 0.5 ft/min. When pressed
and held, speed will automatically increase by 0.5 ft/min
increments until it has reached the maximum allowed speed
of 15 ft/min.
S P E E D
SAFETY
F W D
R E V
15.0
S T O P
G O
21
( 22 ) SPEED
▼
: When pressed, decreases the speed
of the laminator in increments of 0.5 ft/min. When pressed
and held, speed will automatically decrease by 0.5 ft/min
increments until it has reached 0 ft/min.
S P E E D
SAFETY
F W D
R E V
00.0
S T O P
G O
22
( 23 ) GO: When pressed, starts the rollers in motion.
GO is solid. This solid indication is referred to as the “panel
mode”. If a safety shield is raised during “panel mode”,
GO and SAFETY ( refer to ( 27 ) SAFETY for
explanation ) begin flashing enabling “footswitch” mode.
( refer to ( 28 ) FOOTSWITCH for explanation )
S P E E D
SAFETY
F W D
R E V
00.0
S T O P
G O
23
( 24 ) STOP : When pressed, stops the rollers and GO
becomes white.
S P E E D
SAFETY
F W D
R E V
00.0
S T O P
G O
24
