Page 7 - 6
Explorer 107 Operation and Maintenance Manual
© GBC Pro - Tech December 1999
Troubleshooting
7.3.2 Clearing a jam
Film jams ( wrap-ups ) may occur if the film is
loaded backwards or if the area at which film exits the
laminator is blocked. The film, when jammed, wraps
around the main rollers or pull rollers. To clear a jam it is
necessary to rotate the rollers in the reverse direction.
a) Press
O F F
under Motor Speed
immediately to stop the laminator.
1
2
3
4
5
6
7
8
9
10
M O T O R S P E E D
O N
O F F
R E V E R S E
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
W A R N I N G
b) Raise the front safety shield.
c) Remove the pressure plate.
INFORMATION
Locator latches on the pressure plate are
not associated with an interlock switch.
The laminator can operate without
the pressure plate installed.
d) Remove the feed table.
e) Cut the top and bottom film webs.
f) Grasp the loose ends of the web
g) Reinstall the feed table so that the loose ends of
the web rest on top and lock the safety latches
into the interlocks..
INFORMATION
The laminator will operate only when
all safety latches are in the fully
latched position.
h) Close the front safety shield and lock the safety
latches into the interlocks..