GBC AdvancedPunch Pro, Руководство по обслуживанию

Страница: 23 / 400

GBC AdvancedPunch Pro
08/20/2015 Service Call Procedures
1-5
AdvancedPunch Pro Maintenance Schedule
Note: cycles = sheets of paper punched, not impressions.
Customer Maintenance
Area/Unit Period See: Measures Remarks
Punch Die 100K Die cycles GP 6.7.3 Lubrication Oil the punch pins
Die set shoulder bolts 200k Die cycles GP 6.7.4 Inspect and lubricate Grease
Periodic Maintenance
Area/Unit Period See: Measures Remarks
Punch Drive Cams 5000K cycles GP 6.20 Inspect and lubricate
Punch Motor Belt 1,000K cycles GP 6.21 Inspect
Alignment Stepper Belt 1,000K cycles GP 6.21 Inspect
Steering Carriage Belt 1,000K cycles GP 6.21 Inspect
Steering Rollers 1,000K cycles GP 6.14 Inspect and clean Alcohol and Cloth
Punch Clutch Cleaning 1,000K cycles GP 6.24 Clean Cloth
Sensors S1 to S28 500K cycles GP 6.17 Clean Air
Drive and Idler Rollers 1,000K cycles GP 6.14 & GP 6.15 Inspect and clean Alcohol & cloth
Solenoid Module 1,000K cycles GP 6.22 Inspect
Idler Panel Closing Magnet
Latches 1,000K cycles GP 6.16 Inspect
Acceleration Panel Latch 1,000K cycles GP 6.16 Inspect
Paper Path Drive Timing
Belts 1,000K cycles GP 6.21 Inspect and Adjust if
necessary
Diverter Solenoid Assembly 1,000K cycles GP 6.25 Inspect
Die Set Recognition Board
Clips 1,000K cycles GP 6.26 Clean Cloth
Alignment Carriage Rails 500K Cycles GP 6.23 Inspect and Clean Air and Cloth
Die Lock Mechanism and
Die Rail Springs 1000K Cycles GP 6.27 Inspect
Die guide (rail) cleaning 500K cycles GP 6.12 Clean Vacuum
Paper path 1000K cycles GP 6.18 & GP 6.19 Inspect and clean Cloth