7
GB
AdvancedPunch
TM
Pro
C.
Paper Clearing:
When paper is jammed in the paper path of
AdvancedPunch Pro the LCD display shows
the area (Zone 1, 2, 3, 4 or 5) where a sheet(s)
is jammed.
Area
Description
If paper is jammed in Zone 1- Punch Bypass, lift
the paper guide plate located just inside, reach
and remove the jammed paper. To close the
paper guide, raise the handle to unlatch the
mechanism and close it firmly.
If paper is jammed in Zone 2, move the door to
the left, reach in and remove the jammed
paper.
If paper is jammed in Zone 3, press the top lever
while holding the bottom lever. This will unlatch
the chute; continue to open the chute until it
reached the magnet on the left side. Reach in
and remove the paper. To return the chute to the
closed position, move it back in the opposite
direction until the latch mechanism is activated.
If paper is jammed in Zone 5, unlatch the chute,
reach in and remove any jammed paper.
If paper is jammed in Zone 6, move the door to
the right, reach in and remove the jammed
paper.
Before uninstalling the die set, ensure Zone 3
and 5 are cleared of any jammed paper. If there
is no paper found in Zone 3 and 5, then
uninstall the die set to remove any jammed
paper.
(see
Section
4.
Changing
the
Interchangable die sets)
5. USER DISPLAY. OPERATION CONTROLS
Located on the front of the AdvancedPunch Pro is a user interactive
LCD panel that provides Messages; Settings and Information relating to
the functions of the punch unit.
LCD Panel Overview
Messages on the LCD Panel
1.
Ready Bypass
AdvancedPunch Pro is ready to bypass, sheets will not be
punched.
2.
Ready Single Punch
AdvancedPunch Pro is ready to process a punch job, all sheets
through the unit will be punched.
3.
Ready Double Punch
AdvancedPunch Pro is ready to process a punch job, all sheets
through the unit will be punch in the middle of sheet and along trail
edge of the sheet.
4.
Running Bypass
This is displayed when Bypass mode is in operation.
5.
Running Single Punch
This is displayed when Single punch mode is in operation.
6.
Running Double punch
This is displayed when Double punch mode is in operation.
7.
Chip tray Full
When the punch container becomes full of waste paper chips, this
message will be displayed.
8.
Chip tray Out
When the punch container is removed or not fully inserted into the
punch unit, this message will be displayed.
9.
Check die
When the Die Set is removed or not fully inserted into the punch
unit, this message will be displayed. When this message is
displayed the punch unit will run in Bypass mode only.
10. Close Door
When the Front door is open or not completely closed this
message will be displayed.
11. Paper jam
When a sheet of paper becomes jammed within the punch unit,
this message is displayed. See the section of this manual titled
PAPER CLEARING for instructions on how to remove a jammed
sheet.
LCD User Interface Screen Overview
MAIN SCREEN
SETTINGS
INFORMATION
PUNCH MODE
ALIGNMENT
LANGUAGE
PAPER
SIZE
DIE
TYPE
DIE
CYCLES
PUNCH
CYCLES
OFF
SINGLE PUNCH
DOUBLE PUNCH
ENGLISH
FRANCAIS
ESPANOL
DEUTSCH
ITALIANO
ANSI
ISO
FIRMWARE
TAB/COVER
MODE
BACKGAGE
TRAIL
MID
CLEAR COVER
Options:
Options:
Options:
Options:
Options:
Options:
CC BACKGAGE
CC ALIGNMENT
UNITS
MM
IN
