Page 11
A s s e m b l y S t e p 9
BGB 7200
A.Please ensure that the cables connected to the
Bike Monitor (#43)
are within the track of the backside so they do not get
pinchedor damaged during this next process (please see diagram). Slide the track of the
Bike Monitor (#43)
halfway onto
the
Monitor Support Bracket (#06)
B.Now, connect the corresponding cables as shown in diagram No. 7:
- 43a to 47
- 43b to 48
- 43c to 45a
- 43d to 46
C.Then, carefully place and tuck all the connected cables into Hole B as shown in diagram No. 8.
Please note: 1.) there is room for you to tuck the cables upward and downward in the hollow area of the
Center Post (#04)
2.) use care when tucking in cables to avoid injury to your fingers and hands
,
tuck the
Wires (#43a/b/c/d)
on the
Bike Monitor (#43)
through
Hole A (diagram No. 6)
,
then slide the
Bike Monitor (#43)
onto the rest of the track until the monitor locks in place.
Please note: if you need to remove the
Bike Monitor (#43)
, press and hold down the tab on the back of the
Bike Monitor (#43)
to unlock, slide, then release the tab.
-Please connect designated wires to matching numbers (i.e. “1” to “1”; “2” to “2”).
NOTE: Wires do not require excessive force to connect; please use care when connecting.
Assembly Instructions
}
