Gazer TV24-HS2, Руководство пользователя

Страница: 10 / 26

6
EN
Preparation of the TV Set
Note: In case of the normal use, new batteries are to operate about half a
year� If you are not going to use the TV set for a long period of time, remove
the batteries out of the remote�
Installation of the TV Set:
Carry out the operations as follows to use the TV set comfortably and safely:
• Carefully take the device out of the box, remove all transport means of
protection (foam holders, protective wrapping);
• In addition, remove the entire protective film from the device;
• If you are going to fasten the TV set on the wall with a bracket, use the VESA
mounting holes on the back cover of the device;
•
When choosing the installation location, pay attention to the stability of the
surface� An unstable, rocking piece of furniture may be a cause of the TV-set
tipping over;
• While fastening the TV set on the wall fixture, be attentive and reliably fasten
the TV set in order to avoid any injuries from the device fall;
• After installing the TV set, plug in the power-supply cable into the socket� Lay
the power-supply cable so as to avoid any tension or break that may lead to
the cable damage�
Preparation of the Remote Control
To ensure the operation of the control, it is necessary to insert batteries therein�
The remote control is powered by two AAA 1�5 V batteries�
The following operations should be carried out to install the batteries inside the
remote:
•
Carefully open the cover of the battery section;
•
Install two batteries in the correct polarity (pursuant to the diagram inside the
section);
• Carefully close the cover of the battery section�